Before Bridging to a Polygon App, Confirm Its Chain

The Polygon bridge sends supported assets to Polygon PoS only; if your app runs on zkEVM or another chain, you need a bridge for that destination.

  • The app uses Polygon PoS: choose a route that lists Polygon PoS as the destination.
  • The app uses Polygon zkEVM: use a route that lists zkEVM, because a Polygon PoS balance will not appear there.
  • The app names another chain: find a bridge route to that chain before sending funds.

Polygon PoS and zkEVM Keep Separate Balances

Polygon PoS and Polygon zkEVM are separate networks, each with its own bridge contracts and token records. A token balance is recorded on the network where the transfer arrives; sharing the Polygon name does not make balances visible across both chains.

A bridge's destination is the deciding criterion: the Polygon bridge records supported transfers on Polygon PoS. If your app reads balances on zkEVM, that transfer will not fund it, even if the same wallet address is used on both networks.

Consider two cases with the same wallet, token, and Ethereum source. If the app is configured for Polygon PoS, bridging to Polygon PoS puts the funds on the network it reads. If the app is configured for zkEVM, the same transfer leaves the funds on the wrong network for that app. The changed condition is the app's destination chain, so the result changes too.

The App's Network Setting Identifies the Right Destination

The app's network setting or chain ID tells you which destination to select. Chain ID 137 identifies Polygon PoS; 1101 identifies Polygon zkEVM. Look at the network the app asks your wallet to use, rather than relying on a label that says only “Polygon.”

If a transfer has already arrived on the other Polygon network, the app will not see that balance there. You need another bridging route to move the assets to the app's chain, which means additional fees and waiting for that transfer. The available route and timing depend on the networks and provider involved.

Third-party bridges may offer routes to either network, so read the destination shown in the route before approving it. When choosing a Polygon bridge, confirm its destination says Polygon PoS; if the app uses zkEVM, select a route that explicitly names zkEVM. That check tells you whether the funds will arrive where the app can use them.

Comments

Popular posts from this blog

Why Is My Bridge Transfer Still Pending?

acrossbridge: Why destination calls can reject a bridge fill

How to Set Slippage on a Syncswap Swap